used food processing machinery since 1952, with over six warehouses of
used food processing equipment IN STOCK!
NY 14589 U.S.A. 315-589-4511(voice)
ALARD OVERFLOW BRINER OVERFLOW CAN FILLER BRINE FILLER... Click on picture(s) to zoom in!
ALARD OVERFLOW BRINER
All T316 stainless steel contacts.
Adjustable for range of container sizes: 1.5" to
6.5" diameter and 2" to
Variable speed chain conveyor adjustable from 20
to 80 feet per minute.
T316 stainless steel recirculating pump, capable
up to 25 gallons per minute*
over waterfall, with regulating valve to reduce/adjust
flow as desired.
175 gallon brine reservoir, with (steam) heating
Reservoir has hinged covers to provide easy
access while providing
Optional replenishing system can be configured to
briner as needed.
We can offer minor modifications for
special container or capacity
requirements on a custom-quotation basis.
4' long removable front hood covers both briner
and conveyor section. Both front and back covers are hinged. Back cover
removable for maintenance.
3/4" T316 stainless steel 360 degree steam coil
with (2) 3/4" NPT fittings
(in & out), self-regulating temperature-sensing steam control with
bronze body. 1.5" brine inlet fitting, 3/4" temperature probe fitting
3/4" female), and level sensor probe fitting (also NPT 3/4"
diffuser (to prevent wave action).
T316 stainless steel catch screen (removable)
located under conveyor section.
4' stainless steel roller chain conveyor with
stainless steel sprockets and shafts,
and UHMW plastic support bearings.
Adjustable container "tip" section controls fill
level to provide for head space.
3' adjustable overflow weir may be raised or
lowered to accommodate
container heights from 2" to 7".
1/2 HP 230 volt, 3-phase gearmotor conveyor
drive, with electronic AC inverter type variable speed control.
1/3HP 3,450 RPM pump motor, 110/220 volt single
phase motor (3 phase available). Flow
is controlled by stainless steel ball valve.
Water/corrosion resistant switch box populated
with on/off switch
for briner pump, starter relay for briner pump, and relay for tank pump.
Electronic level sensor w/T316 stainless
steel probe, with relay to external brine source.
3 phase Centrifugal ReplenishingPump
to pump brine from your brine
mixing tank. 1/2HP, 230/460, 3-phase. Assuming close placement+
briner, this pump should be suitable to exceed the maximum outflow of
briner unit, such that replenishment and mixing of replacement brine is
BRINE MIX TANK - May be quoted to customer
specification; --ask your Alard Sales Representative.
*Gallon capacities are based on
free-flowing liquids like brine, or broth. +Depending on your installation, placement of the
tank vis a vis your briner, and the distance and routing of the
pipe, you may need a larger pump to provide sufficient replenishment
stated, volume, speed, and/or capacity estimates given are those of the
manufacturer(s) of the equipment. All offers are subject to prior sales
and owner's confirmations. Unless otherwise specified, any prices shown
do not include skidding, crating, or freight.